Bucket Elevator

The buckets are of seamless type made of 3.15 mm thick steel sheet. Bucket Elevator is fabricated From Ms material of 5mm Thick at boot section3.15mm thick at trunk and top section, respectively, Aone-piece cast iron pulley; which has been crowned for tracking & rubber lagged to prevent slippage, are located in the boot & head section of the elevator to drive the belt.

All abrasive recovery system inculde three basic functions:

• Delivering the abrasive which rebounds off the workpiece too a central point.
• Transporting the abrasive from the central point to an abrasive cleaner.
• Removing dust, fines & other unwanted 3. material from the abrasive before it enters the blast machine to re-use.

Mechanical Recovery System
Consists of Bucket Elevator, Abrasive Cleaner & Screw Conveyor System

Pneumatic Recover System
Conssits of Mini Hopper, Plenum, Reclaimer & Dust Collector

Abrasive Cleaner
The media sepration unit is an air wash rotary screen seprator which receives all media and debris from blasted work piece by the bucket elevator. Contaminants are removedby rotary screen & are discharged through a chute. the finer contaminants are abrasive that passes through the screen then cascade over the air wash where fine contaminants and small abrasive particles are removed Reusable abrasive falls in the machine.

Screw Conveyor

The reclaim floors utilize a heavy-duty screw to return the abrasive to the seprator / classification systme. The standard screw is 9" in diameter, which consists of a 5" diameter schedule - 40 pipe wrapped with 1/4" thick flighting.